nday
CVE-2026-99338

KVM: TDX: Enable Notify VM exit

Linux / Linux

CVE 공개: . nday가 아직 패치 근거를 수집하지 않았습니다. 패치가 없다는 뜻은 아닙니다. PoC 출처 4곳 모두 미등재. CISA KEV 미등재.

tags productLinux kernel product typeoperating system
why these tags

nday derives these tags by fixed rules from the facts below; NVD, the CNA and other sources do not assign them. Vocabulary and rules: ~/tags.

Linux kernel
affected products in the CVE record: Linux · Linux
operating system
affected products in the CVE record: Linux · Linuxthe product type of Linux kernel in nday's product registry
현재 단계
DIS
공개
CVSS
점수 없음

생명주기

가로축 UTC. 점 = 분 단위, 넓은 막대 = 날짜만, 빈 표시 = 불명 또는 추정.
시점 알 수 없음
DIS공개
11-19T14:21Z
PAT패치
아직 기록 없음
ANA분석
아직 기록 없음
POCPoC
아직 기록 없음
ITW악용
아직 기록 없음
KEVKEV
아직 기록 없음

요약

In the Linux kernel, the following vulnerability has been resolved:

KVM: TDX: Enable Notify VM exit

Enable Notify VM exit functionality for TDX guests.

Notify VM exit is an existing feature supported by KVM. Userspace can enable Notify VM exit through KVM_CAP_X86_NOTIFY_VMEXIT when it's reported as supported. However, KVM reports the support of this CAP just based on the hardware capability but doesn't differentiate between VMX and TDX. This leads to the issue that userspace can enable this cap for TDX guests without getting an error, but the feature is not actually enabled because KVM doesn't call the TDX module API to program the relevant TD VMCS fields.

Enable Notify VM exit for TDX guests by:

- Invoking TDX module API calls to set NOTIFY_VM_EXITING and Notify Window in TD VMCS. It's done in tdx_vcpu_init() where other TD VMCS bits are set. Since TDX vCPU cannot be reset, it only needs to be configured once when initializing the TDX vCPU.

- Adding corresponding exit handler for TDX Notify VM Exit.

Notify VM exit can happen when executing the IRET instruction. If the IRET unblocks the NMI blocking state, bit 12 of the exit qualification is set. In this case, the VMM needs to restore the "blocked by NMI" state when it decides to re-enter the guest. For TDX, KVM cannot manage the GUEST_INTERRUPTIBILITY_INFO and it's TDX module's responsibility to handle it. Extract the common part without NMI blocking handling into a helper in common.h so that it can be shared between VMX and TDX.

Note, KVM uses "pre-production" terminology for the feature formally called Notify VM-Exit. All public versions of the SDM refer to the feature as Instruction Timeout. This will be remedied in the near future, for now, use KVM's terminology for consistency.

Note, #2, there is no enumeration bit for Notify VM exit by TDX module because all TDX modules support it, and allow to set the corresponding TD VMCS fields as long as the hardware supports the feature.

Original text of the CVE record (cvelist), shown as published.

이벤트 로그

+DISCVE 공개

CVE 레코드 공개(CNA: Linux).

출처 cvelist · nday 실시간 관측 · 원본
{
  "id": 484654,
  "type": "disclosed",
  "source": "cvelist",
  "url": "https://www.cve.org/CVERecord?id=CVE-2026-99338",
  "occurred_at": "2026-11-19T14:21:46.037Z",
  "observed_at": "2026-11-19T15:00:30.436713Z",
  "is_backfill": false,
  "dedupe_key": "",
  "detail": {
    "state": "PUBLISHED",
    "date_published": "2026-11-19T14:21:46.037Z",
    "assigner_short_name": "Linux"
  }
}

Report an error

report an error or omission

Something on this page wrong or missing? Tell the editors; if they accept it, this page's revision log says so publicly. Upstream data is not changed.

연구자 논의

최근 7일간 연구자 0명이 언급

목록의 연구자가 X에서 이 CVE를 언급한 게시물입니다. 원문 그대로 보여 주며 nday는 검증하지 않습니다.

명단의 연구자가 X에서 이 CVE를 언급한 게시물은 아직 수집되지 않았습니다.

Discussion

0 comments

No comments yet.