nday
CVE-2026-98797

net: cap skb->queue_mapping when the tx queue is picked

Linux / Linux

に公開されました。nday はまだ修正の根拠を取得していません。修正がないという意味ではありません。4 つの PoC ソースのいずれにも未掲載です。CISA KEV には現時点で未掲載です。

tags productLinux kernel product typeoperating system
why these tags

nday derives these tags by fixed rules from the facts below; NVD, the CNA and other sources do not assign them. Vocabulary and rules: ~/tags.

Linux kernel
affected products in the CVE record: Linux · Linux
operating system
affected products in the CVE record: Linux · Linuxthe product type of Linux kernel in nday's product registry
現在の段階
DIS
公開日時
CVSS 基本値
スコアなし

ライフサイクル

横軸は UTC。点=分単位、幅広の帯=日付のみ、白抜き=不明または推定。
日時不明
DIS公開
10-18T15:48Z
PAT修正
記録なし
ANA解析
記録なし
POCPoC
記録なし
ITW悪用
記録なし
KEVKEV
記録なし

概要

In the Linux kernel, the following vulnerability has been resolved:

net: cap skb->queue_mapping when the tx queue is picked

skbedit can set skb->queue_mapping and raise the per-CPU skip_txqueue flag so __dev_queue_xmit() honours the mapping. __dev_queue_xmit() cleared the flag before sch_handle_egress() and only read it afterwards, so the flag was not confined to the xmit that set it: a nested xmit (mirred redirect or mirror, or a drop after skbedit) could set the flag and the outer xmit would consume it for an skb that never went through skbedit.

A forwarded packet still carries the ingress NIC's rx_queue + 1 in skb->queue_mapping, so the outer device then indexes its tx queue state with that stale value. Taprio's child array q->qdiscs[] is sized to the device's queue count, so taprio_enqueue() indexes past its allocation and dereferences the result as a struct Qdisc *.

We (ab)use the skb->nf_skip_egress which means "skip netfilter egress for this packet" to tag to "am I in tc egress?". Despite the overload I dont see it as a conflict since the marker is set only around the single sch_handle_egress() call and ingress path is guarded by tc_at_ingress. I will send a followup(net-next) patch once this hits net-next to rename the skb->nf_skip_egress bit/flag to skb->skip_egress

Arm the flag only from the egress classifier that can use it: raise skip_txqueue from tcf_skbedit_act() only when it runs inside sch_handle_egress(), thanks to skb->nf_skip_egress. An egress qdisc classifier runs in q->enqueue(), after the tx queue has been picked, so a mapping it sets cannot affect the current packet; arming the flag there only pollutes it for a later xmit. Then own the flag for the xmit frame the egress hook runs in: save the incoming value and clear it just before sch_handle_egress(), and restore it after the hook - on the consumed (drop) path, or, in the same call that reads it, on the surviving path. The save and the restores stay inside the egress_needed_key static branch, so a packet pays for them only when egress hooks are active (2f1e85b1aee4).

Store the value netdev_cap_txqueue() selected back into skb->queue_mapping in netdev_tx_queue_mapping(), as netdev_core_pick_tx() already does, so the skip_txqueue path never hands a later reader on the xmit path a mapping the device cannot serve. A store made still later in the same frame, by a tc BPF program attached to a transmit qdisc, is outside this path and is not re-capped; a separate followup will resolve that path.

netdev_xmit_skip_txqueue() returns the previous flag value so the save-and-clear is one call, and a no-op stub is provided when CONFIG_NET_EGRESS is disabled. skb->nf_skip_egress is compiled under CONFIG_NET_EGRESS rather than CONFIG_NETFILTER_SKIP_EGRESS, so skb_at_tc_egress() is valid whenever the egress path is built.

A local user in a network namespace can redirect a packet from a device with more TX queues to one with fewer after setting a mapping valid only on the larger device. That reaches these reads and, under KASAN, faults with "slab-out-of-bounds in taprio_enqueue".

Conditions to recreate the bug: the report's own trigger is a local user with CAP_NET_ADMIN in a network namespace, so no eBPF program is needed. With CONFIG_NET_SCH_TAPRIO=y, CONFIG_NET_ACT_SKBEDIT=y, CONFIG_NET_ACT_MIRRED=y, CONFIG_NET_CLS_MATCHALL=y, CONFIG_NET_SCH_PRIO=y and KASAN enabled, create qa (3 queues), qb (2 queues) and qc (1 queue) as dummy devices; put a taprio root on qb (num_tc 1, queues 2@0) and clsact on all three; then add an egress matchall filter on every device. On qa: "action skbedit queue_mapping 2 pipe action mirred egress redirect dev qb". On qb: "action mirred egress mirror dev qc". On qc: "action skbedit queue_mapping 0 pipe". Send one packet out qa. qc's skbedit sets the flag while qb's outer xmit is in flight; without the fix qb consumes it and reads its two-entry taprio child array with the forwarded packet's stale mapping. A qc whose skb ---truncated---

Original text of the CVE record (cvelist), shown as published.

イベント履歴

+DIS公開

Linux が CVE レコードを公開。

出典 cvelist · nday が に一括取り込み · 生データ
{
  "id": 458080,
  "type": "disclosed",
  "source": "cvelist",
  "url": "https://www.cve.org/CVERecord?id=CVE-2026-98797",
  "occurred_at": "2026-10-18T15:48:41.613Z",
  "observed_at": "2026-11-13T05:40:20.493151Z",
  "is_backfill": true,
  "dedupe_key": "",
  "detail": {
    "state": "PUBLISHED",
    "date_published": "2026-10-18T15:48:41.613Z",
    "assigner_short_name": "Linux"
  }
}

Report an error

report an error or omission

Something on this page wrong or missing? Tell the editors; if they accept it, this page's revision log says so publicly. Upstream data is not changed.

研究者の投稿

過去 7 日間に 0 人の研究者が言及

リストの研究者が X でこの CVE に触れた投稿です。原文のまま表示し、nday は検証していません。

リストの研究者が X でこの CVE に触れた投稿は、まだ収集していません。

Discussion

0 comments

No comments yet.