nday
CVE-2026-90338

serial: amba-pl011: keep console clock enabled for atomic writes

Linux / Linux

に公開されました。nday はまだ修正の根拠を取得していません。修正がないという意味ではありません。4 つの PoC ソースのいずれにも未掲載です。CISA KEV には現時点で未掲載です。

tags productLinux kernel product typeoperating system
why these tags

nday derives these tags by fixed rules from the facts below; NVD, the CNA and other sources do not assign them. Vocabulary and rules: ~/tags.

Linux kernel
affected products in the CVE record: Linux · Linux
operating system
affected products in the CVE record: Linux · Linuxthe product type of Linux kernel in nday's product registry
現在の段階
DIS
公開日時
CVSS 基本値
スコアなし

ライフサイクル

横軸は UTC。点=分単位、幅広の帯=日付のみ、白抜き=不明または推定。
日時不明
DIS公開
09-17T16:08Z
PAT修正
記録なし
ANA解析
記録なし
POCPoC
記録なし
ITW悪用
記録なし
KEVKEV
記録なし

概要

In the Linux kernel, the following vulnerability has been resolved:

serial: amba-pl011: keep console clock enabled for atomic writes

pl011_console_write_atomic() runs from nbcon atomic context, where sleeping is not allowed. It calls clk_enable(), which takes the common-clk enable_lock. Under PREEMPT_RT that is a sleeping lock: clk_enable_lock() first tries spin_trylock_irqsave(), but on contention falls back to spin_lock_irqsave(). Therefore, an atomic-context printk on an RT kernel with a clk-backed pl011 can trip:

BUG: sleeping function called from invalid context at spinlock_rt.c:48
  __might_resched from rt_spin_lock
  rt_spin_lock from clk_enable_lock
  clk_enable_lock from clk_enable
  clk_enable from pl011_console_write_atomic
  ... from vprintk_emit

This was found and reproduced on PREEMPT_RT. Arm32 and arm64 DT SoCs are affected; arm64 SBSA/ACPI has no clk, so clk_enable(NULL) short-circuits before the lock. In addition, write_atomic() may be invoked from NMI context and is documented to avoid locking. Removing clk_enable() from the callback also avoids a potentially unsafe NMI acquisition of the common-clock enable_lock.

An nbcon atomic-capable console must be printable from any context, so the clock cannot be gated between writes. Enable the clock while the console is available for output: use clk_prepare_enable() in pl011_console_setup(), release it via clk_disable_unprepare() in the console .exit() callback, and drop the per-write clk_enable()/clk_disable() pairs from write_atomic() and write_thread().

When printk suspends consoles, drop the reference after uart_suspend_port() stops console access and restore it before uart_resume_port() -- but only if suspend actually marked the port suspended (a wake-capable tty stays running and must keep its clock), and keep it when console_suspend_enabled is false so no_console_suspend works.

The active power cost of keeping the clock enabled is platform-dependent: none where the UART clock is a fixed always-on oscillator, real where it is a gateable clock branch, which then cannot be gated (nor possibly can its parent clocks) while the console is available for output. When serial core actually suspends the port, the reference is released so the clock provider can gate the clock tree.

Original text of the CVE record (cvelist), shown as published.

イベント履歴

+DIS公開

Linux が CVE レコードを公開。

出典 cvelist · nday が に一括取り込み · 生データ
{
  "id": 453022,
  "type": "disclosed",
  "source": "cvelist",
  "url": "https://www.cve.org/CVERecord?id=CVE-2026-90338",
  "occurred_at": "2026-09-17T16:08:50.331Z",
  "observed_at": "2026-11-13T05:40:16.734465Z",
  "is_backfill": true,
  "dedupe_key": "",
  "detail": {
    "state": "PUBLISHED",
    "date_published": "2026-09-17T16:08:50.331Z",
    "assigner_short_name": "Linux"
  }
}

Report an error

report an error or omission

Something on this page wrong or missing? Tell the editors; if they accept it, this page's revision log says so publicly. Upstream data is not changed.

研究者の投稿

過去 7 日間に 0 人の研究者が言及

リストの研究者が X でこの CVE に触れた投稿です。原文のまま表示し、nday は検証していません。

リストの研究者が X でこの CVE に触れた投稿は、まだ収集していません。

Discussion

0 comments

No comments yet.