nday
CVE-2022-50818

scsi: pm8001: Fix running_req for internal abort commands

Linux / Linux

に公開されました。nday はまだ修正の根拠を取得していません。修正がないという意味ではありません。4 つの PoC ソースのいずれにも未掲載です。CISA KEV には現時点で未掲載です。

tags productLinux kernel product typeoperating system
why these tags

nday derives these tags by fixed rules from the facts below; NVD, the CNA and other sources do not assign them. Vocabulary and rules: ~/tags.

Linux kernel
affected products in the CVE record: Linux · Linux
operating system
affected products in the CVE record: Linux · Linuxthe product type of Linux kernel in nday's product registry
現在の段階
DIS
公開日時
CVSS 基本値
スコアなし

ライフサイクル

横軸は UTC。点=分単位、幅広の帯=日付のみ、白抜き=不明または推定。
日時不明
DIS公開
2025-12-30T12:08Z
PAT修正
記録なし
ANA解析
記録なし
POCPoC
記録なし
ITW悪用
記録なし
KEVKEV
記録なし

概要

In the Linux kernel, the following vulnerability has been resolved:

scsi: pm8001: Fix running_req for internal abort commands

Disabling the remote phy for a SATA disk causes a hang:

root@(none)$ more /sys/class/sas_phy/phy-0:0:8/target_port_protocols sata root@(none)$ echo 0 > sys/class/sas_phy/phy-0:0:8/enable

root@(none)$ [   67.855950] sas: ex 500e004aaaaaaa1f phy08 change count has changed
[   67.920585] sd 0:0:2:0: [sdc] Synchronizing SCSI cache
[   67.925780] sd 0:0:2:0: [sdc] Synchronize Cache(10) failed: Result: hostbyte=0x04 driverbyte=DRIVER_OK
[   67.935094] sd 0:0:2:0: [sdc] Stopping disk
[   67.939305] sd 0:0:2:0: [sdc] Start/Stop Unit failed: Result: hostbyte=0x04 driverbyte=DRIVER_OK
...
[  123.998998] INFO: task kworker/u192:1:642 blocked for more than 30 seconds.
[  124.005960]   Not tainted 6.0.0-rc1-205202-gf26f8f761e83 #218
[  124.012049] "echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
[  124.019872] task:kworker/u192:1  state:D stack:0 pid:  642 ppid: 2 flags:0x00000008
[  124.028223] Workqueue: 0000:04:00.0_event_q sas_port_event_worker
[  124.034319] Call trace:
[  124.036758]  __switch_to+0x128/0x278
[  124.040333]  __schedule+0x434/0xa58
[  124.043820]  schedule+0x94/0x138
[  124.047045]  schedule_timeout+0x2fc/0x368
[  124.051052]  wait_for_completion+0xdc/0x200
[  124.055234]  __flush_workqueue+0x1a8/0x708
[  124.059328]  sas_porte_broadcast_rcvd+0xa8/0xc0
[  124.063858]  sas_port_event_worker+0x60/0x98
[  124.068126]  process_one_work+0x3f8/0x660
[  124.072134]  worker_thread+0x70/0x700
[  124.075793]  kthread+0x1a4/0x1b8
[  124.079014]  ret_from_fork+0x10/0x20

The issue is that the per-device running_req read in pm8001_dev_gone_notify() never goes to zero and we never make progress. This is caused by missing accounting for running_req for when an internal abort command completes.

In commit 2cbbf489778e ("scsi: pm8001: Use libsas internal abort support") we started to send internal abort commands as a proper sas_task. In this when we deliver a sas_task to HW the per-device running_req is incremented in pm8001_queue_command(). However it is never decremented for internal abort commnds, so decrement in pm8001_mpi_task_abort_resp().

Original text of the CVE record (cvelist), shown as published.

イベント履歴

+DIS公開

Linux が CVE レコードを公開。

出典 cvelist · nday が に一括取り込み · 生データ
{
  "id": 280036,
  "type": "disclosed",
  "source": "cvelist",
  "url": "https://www.cve.org/CVERecord?id=CVE-2022-50818",
  "occurred_at": "2025-12-30T12:08:33.548Z",
  "observed_at": "2026-11-13T05:37:51.196939Z",
  "is_backfill": true,
  "dedupe_key": "",
  "detail": {
    "state": "PUBLISHED",
    "date_published": "2025-12-30T12:08:33.548Z",
    "assigner_short_name": "Linux"
  }
}

Report an error

report an error or omission

Something on this page wrong or missing? Tell the editors; if they accept it, this page's revision log says so publicly. Upstream data is not changed.

研究者の投稿

過去 7 日間に 0 人の研究者が言及

リストの研究者が X でこの CVE に触れた投稿です。原文のまま表示し、nday は検証していません。

リストの研究者が X でこの CVE に触れた投稿は、まだ収集していません。

Discussion

0 comments

No comments yet.